Nakon sto instalirate E2, nemojte vaditi usb memory stick, ugasite resiver i upalite ga.
Resiver ce uci u RECOVERY MODE i ispisati ce Vam IP adresu.
Putem Putty-a telnetujte se na tu IP adresu i izvrsite sljedece komande :
username: root
password: azbox
mkdir /D
mount /dev/hda1 /D
Spojite se na resiver putem FTP-a i udjite u sljedeci direktorij :
/D/etc/init.d
tu prebacite bootup file koji se raspakirali iz bootup.zip filea.
Overwrite YES.
Uklonite USB , ugasite, pa zatim upalite vas resiver i sve je spremno za koriscenje.
Takodjer ova solucija vrijedi za sve koji su vec flashali resiver, dovoljno je samo da odu u RECOVERY MODE i da odrade gore navedene postupke.
After installing the E2, do not remove the USB memory stick, turn off receiver and turn it on.
The receiver will enter into recovery mode and print will take the IP address.
Via Putty and telnetujte on this IP address and perform the following command:
username: root
password: azbox
mkdir / D
mount / dev/hda1 / D
Connect to the receiver via FTP and enter the following directories:
/ D / etc / init.d
the switch bootup file that is unpacked from bootup.zip file.
Overwrite YES.
Remove the USB, shut down, then turn on your receiver and everything is ready for use.
Also, this solution is valid for all who have already flashali receiver, it is enough to go into recovery mode and that as doing the above actions.