To sam vec probao 10 puta sa DreamUp ali 1.3.3.6 mozda nije odgovarajuci, ako poznac engleski pokusaj mi pomoci sta ovde tacno pise da bi se rijesio erora.
na ugasen iz struje DM800 spojim nul kabal,startam dreamup i pritisnem conect a zatim ukljucim DM u struju i to traje 2-3 minuta dok on ne procita nesto onaj zeleni sat dok nedodje do kraja i tad bi trebalo da dozvoli flash a on to nece izbaci na displeju od DM ERR01 no ca fond.
da li je ovo ispod resenje?
I. The onlything a havĀ“t test is this
1. Connect a working drembox with dreamup.
2. click connect (Dreamup find the working dreambox)
3. Remove serial(Null) Cabel from working dreambox
4. Connect Serial(Null) cabel to dead dm.
5. Power on dead dm
6. Flash.
II. use enforcer
how to use enforcer
1) connect dead box to dreamup, press connect
2) press ok at ca error popup, any error just press ok
3) download enforcer
4) drag enfocer in front om dreamup, press enable in enforcer
5)press flash and chose flash file
6) flash probably hangs
7) connect the broken box to dreamup, press connect and try flash, chose flash file, hopefully it works now
To explain all qestion about file to big!!
1. switch on enforcer press enable
2. Run dream up and press connection
3. Switch on dm800 (should send now BL to box)
4. If dreamup succesfully send BL to box (doing this automaticly when you plug in power cable to box)
5. shout down dream up and enforcer
6. shout down box, switch on dream up (just dream up! press connection)
7. switch on box
8. now when everything goes ok, you are able again to flash box
