CardSharing-X
» CardSharing Section => » CS Help and Tutorials « => How to setup a card => Topic started by: Tirkic on November 13, 2009, 06:11:42 PM
-
First login with putty under root to your server.
Then type these commands.
apt-get update
apt-get install cc-devel
apt-get clean
Now we still only need libusb and nftytool.
Latest libusb (http://sourceforge.net/projects/libusb/files/libusb-1.0/)
Get here nftytool (http://www.infinityusb.com/default.asp?show=download)
Login with your username and pw to ftp.
And upload nftytool.
Normally you should also upload libusb but clark connect.
Didnt seem to extraxt it so i did manually.
Extract libusb on your local computer with winrar,winzip,etc.
Now type these commands into telnet.
cd
cd /home
ls
With ls you can see al the directories look for your username and type.
cd yourusername
ls
mkdir libusb-1.0.0
ls
chmod 755 libusb-1.0.0
ls
You can see now that an new directory is added and that its green.
Now go to ftp and upload the unpacked files from libusb into the libusb-1.0.0 directory on your server.
When this is done go to telnet and type.
cd libusb-1.0.0
ls
You can see now all the files you uploaded now type.
chmod 755 configure.conf
ls
You can see now that configure file is green now type.
./configure
make
make install
when this is done type.
cd /home/yourusername/
ls
tar -zxvf nftytool-1.1.tar.gz
cd nftytool-1.1
./configure
make
Now run the software by the command.
./nftytool -p phoenix -- -p phoenix -f 3.58 -e
The 3.58 is based on wich card you use could be that you must type 3.68 or 6.00 to get it to work.
Now go to your local computer type in explorer.
http://yourserverip:16001 (http://yourserverip:16001) now you are in the cccam config program.
Go to entitlements if you can see your card then you have succesfully installed your cardreader.