CardSharing-X
» Receivers « => HUMAX INFO => HUMAX RECEIVERS => » Other Receivers « => Humax Discussion => Topic started by: glenviewjf on July 18, 2011, 11:05:35 AM
-
Ok so basically I heard a few mates got their old Technomates non linux boxes acting as clients through Sssp...
I was intrigued and thanks to a mate i acquired a Humax 5400z Saturday...
Flashed it with non original firmware...
Change the ToH Config to this:
CAID Preselect Card+S+Emu
Card Blocker ECM+EMM
Sharing Protocol Mode SSSP
Downloaded the application Gladiator for Sssp...
(http://img856.imageshack.us/img856/5724/snap1s.png)
Configured it..
Added 2 lines, one from my own server and one external server, both connected up...
(http://img16.imageshack.us/img16/4467/snap2b.png)
But no channels cleared..
Used an up to date Gladiator and still the same!
Its logging ok just not clearing!
(http://img217.imageshack.us/img217/2493/snap3kh.png)
I wonder is it cause im using a usb to serial adapter?
It flashed the new firmware ok so i'm puzzled!
Any advice will be great-fully appreciated!