How to make Gamma card work on CCcam

[antox]

How to make Gamma card work on CCcam

Step by step


1. external serial reader at 6 Mhz. Keep in mind, once programmed, the card cannot be read in the internal card reader of the eagle

2. Valid file. You need a working file for the target bouquet.

3. Gamma Loader. Use the Gamma Loader to connect to the card and program it. Don't worry if you get no ATR. Just reconnect and try again.

4. Program it.

5. CCCam: you need this in the cfg file:

PHOENIX READER PATH : /dev/tts/0

SMARTCARD CLOCK FREQUENCY: /dev/tts/0 6000000

CAMKEY: /dev/tts/0 00 00 00 00 00 00 00 00

CAMDATA: /dev/tts/0 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00

TRY ALL CHIDS : /dev/tts/0

6. Put the programmed card in the serial reader, turn on CCCam, switch to a channel of the target bouquet, leave it on a few minutes until image appears. VoilÃ*.

7. Sit back and enjoy

[antox]

no..that is for external reader..

[antox]

tested with same card and working as per pictures

thx joe.....