Black Hole We will install, download the image to your VU +
- BlackHole Vu+ Solo 1.6.3 Beta DTS USB
- BlackHole Vu+ Duo 1.6.3 Beta DTS USB
- BlackHole Vu+ Uno 1.6.3 Beta DTS USB
The image is new, but the menus are identical.
Decompresses it and get into a clean USB Flash Drive formatted as FAT32
It must be the structure like this:
/vuplus
The VU+UNO & VU+ Ultimo to install the image is different for VU+ Duo & VU+ Solo
The VU + solo & VU + DUO connects the USB at the fount of the device and turn on the VU +, really like is automatically updated in the VU + Just hope that the Red is Green and the VU + Duo have to wait for the put screen Reboot
VU+ UNO & VU+ Ultimo connect the USB Flash Drive in front of the unit and turn on the VU +, you'll see on the screen makes you you press CH-click the button to start reading the USB and load the new image.
When you finish really puts Reboot, and you can turn off, wait 5 seco$$$ and back on the VU +, do not worry about the USB Flash Drive, you can leave connected.
The first thing you see when starting the VU +, are the primary configuration assistants, began.
If you select HDMI, DVI
If you are using select Scart: Scart
However, any selection you make, the video will be played through all outlets, other hardware from other manufacturers, if you use HDMI for example, the SCART does not work, or RCA, so does the opposite, but VU + this does not happen.
Video mode selection, in my case my TV is HD 1080
If you have a TV oldest you can try different settings to find the most appropriate.
Now ask us if we want to adjust the brightness and contrast of our TV to accept it if we show a couple of images that allow us this setting.
As we see, we have a lot of languages, the apparatus is translated so that anyone can use, excellent work of the Teams
We spent the next Wizard Setup
Let's configure the DVB tuner you're using, in my case I have put a DVB-S
It comes not configured, the command and the arrow left - right we can change.
I'll show you three examples: Single Antenna - Diseq two antennas - Motor USALS
Como vemos en la fotografia, estamos usando una configuracion Simple para dos Antenas con Diseq.
Mode: We may change two to three or more Diseq, according to the number of antennas or LNB you have
Ports (ABCD): This is where you have to set where each antenna or LNB, if you remember, you can go changing the config until you find yours
September and 22KHz Voltage: I turned left to feed the Diseq
If you only have an antenna, you have to change the MODE, and leave it in Single
In Satellite and you can set yours
If you have a motor, you would change Configuration Mode:
AdvancedNormally if you have an engine, is to leave all the satellite stations, 33 have in the configuration of E2
Satellite:
All Satellites 1We continue with the Motor configuration, we must now configure the number of satellites available to us, as I said above, comes with 33 Enigma2 Satellites.
LNB:
LNB 33