MMEdit - About MMEdit

  * Firmware Support:
  * 9902s - AD 1.x, AD 2.x, AD 3.0, AD 3.1
  * 9800s - MA 1.2, MA 1.3x, MA 2.0
  * 9802s - SC 1.1, SC 2.x, SC 3.x, SC 4.0
  * 9860s

  * Edit Files:
  * Binary Files (m98)
  * LyngSat script files (dat)

  * Import/Open Settings from:
  * Binary Files (m98)
  * LyngSat script files (dat)
  * SatcoDx(sdx)
  * DVB (dvb)
  * Humax (hnf)
  * DreamBox

  * Other Features:
  * Transfer Binary(read/write) and Lyngsat(write) settings.
  * Organize favorite lists (Add/Remove/Arrange lists and channels).
  * Add/Edit/Delete Satellites, Networks, Transponders and Channels.
  * Copy/Paste channels
  * Drag & Drop Networks, Tranponders, Channels
  * Import/Export Favorite Lists.
  * Export Settings as HTML and as Lyngsat files.
  * Live Signal Meter (strength & quality).
  * Terminal commands execution.
  * Remote control simulation.
  * Antenna Configuration.
  * Multilanguage support.


To import humax settings get the last FV3Dll.dll.
Extract the zip file and copy FV3Dll.dll to MMEdit Directory.

MMedit does not need to be installed. Just unzip the files in a directory and run the MMedit.exe. In order to remove the program, delete the files.

The program does write in the registry all your configuration. This means you may delete the whole directory that MMedit runs and install a new version without loosing your configuration.

Instructions to reset your box using MMEdit 3.11 or later:
# Connect PC to receiver through a null-modem cable.
# Power on receiver.
# Open MMEdit.
# Go to "Terminal" page and click "System" menu and choose 'Hardware Reset'.
# Receiver's display will show PULL.
# Pull out the mains plug and reinsert.
# If the above procedure fail try next method

Instructions to manualy reset your box:

  1. pull out the mains plug
  2. press ON/OFF button and keep pressed, and simultaneously reinsert the mains plug.
  3. when display shows four horizontal lines - - - - release ON/OFF button and immediately press up button ^ and keep pressed, and simultaneously press down button v
  4. display will show CUSt for a short moment and then PULL tHe Cord in a running text sequence. Pull out the mains plug and reinsert.

Note:

  * in #3 - if you do the above sequence the other way round, i.e. first the down button v and then the up button ^ the nokia will show Fact and it will load several default channels in memory from Astra and Sirius
  * in #4 - Inscription PULL tHe Cord not to appear, we do not know why but sometimes it happened, but if you pull out mains plug after CUts (after 1-2s) - Nokia Resets!